1.8 tddi rough idle. Hi all. new to the forum so if this topic has already been covered I apologise in advance.I have a 05 reg mk1 1.8 tddi van.the problem I have is when it's idling it's running like it's missing or down on a cylinder.It's driving fine once it's above 1800-2000 rpm but anything below isn't great.I've had the injectors tested
Hi again Guys,Well I finally got a new C/H Temp Sensor on eBay for £25 (New). I have now got the Haynes w/s Manual for my 2006 TDCi Mondeo also, however the manual was of little help on this (typical) Anyway, I got stuck-in and here's the route I took should this be useful for future reference to anyone suffering the same problems I had.How check Siemens injectors for Ford S-Max 1.6 2012 with Siemens injectors and coding after replace to new injectors.(((Subscribe, Like, Comment - Best Chann
Hi all, Yesterday I looked at upgrading my 2008 1.8 TDCI for a 2009 1.8 TDCI, I noted 3 of the injectors had their reference numbers blanked out per Pic attached. I assume that could represent 3 of the 4 injectors have been reconditioned but I am guessing so would be greatful for opinions please.First and simplest method to do it, you can simply use an injector cleaner to maintain the injectors of your Ford Focus . This additive which will just cost you about fifteen euros and will allow you to maintain your injectors. Indeed, this product will have a very moderate performance if your injectors are already clogged, but used every 5000
Hi everyone, On Mondeo MK4 2009 1.8 TDCI 125 My car goes in limp mode even at idle, OBD scanner gives error P0201. I would try to replace the injector
P0200 Injector Circuit. i cleared the codes and started the car and same as before as i took my foot off the clutch it would stall. i rechecked the codes and same as before these codes came up. P0200 Injector Circuit. P0190 Fuel Rail Pressure Sensor A Circuit. P0200 Injector Circuit. Any clues to what it could be would be very helpful and ThanklM3Opp.